Peugeot 308 Key Fob Replacement
Peugeot's 308 is a bit old, but it is still attractive. It's not the most luxurious car in its class It's a Ford Focus or Volkswagen Golf will protect you from road imperfections, but it's still a pleasant and pleasant driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is constant or intermittent these tips will assist.
Water Damage
If you accidentally drop your key fob into a puddle or it gets wet while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outdoors or do activities that expose it to excessive amounts water.
You'll also want to make sure that the fob is dry prior to opening it and reusing it. If you notice any odors coming from the fob, such as an industrial-type liquid smell or windshield washer fluid, this is another sign that it's been submerged in water.
A circuit board that's wet can cause the battery to dump its charge or even explode. If you're able to pull the 308 key fob of the water body it was stuck in turn the button upside down and shake it out as much water as you can before opening the case. Remove the battery, then clean the circuit board using a cotton swab which has been dipped into 90-percent alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not work include a dead battery in the coin-cell or receiver module issue signal interference or a faulty chip. If none of these are the cause, you can reset the system by removing the 12 volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to entering. peugeot keys is extremely helpful, especially during winter's cold and chilly months. Remote start systems may cease to function for a variety reasons, including a dead coin-battery.
A coin-shaped battery in the key fob will last a time of between two and four years, depending on how often used and where it's purchased. The date of use is usually printed on the packaging or listed in the instruction manual.
If the key fob stopped functioning after exposure to clean tap water then you must remove the battery, clean the chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. In the event of exposure to soapy or salty water, the chip may be damaged and you'll require replacing the key fob entirely.
If you're unsure if that the battery is not working properly, you can test the voltage with an instrument set to the vehicle's voltage range and connected to the minus and plus terminals. If the voltage is lower than 12-13 volts, then you should replace the battery. Alternately, you could try to reset the onboard computer by disconnecting the battery with 12 volts for a few minutes and reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.
Faulty Receiver Module
If you don't see the "Key Detected" you might find that your receiver module is malfunctioning. It's that part that sends an indication to the car when your key fob is activated, which acts as an immobiliser and prevents it from starting until the key that you want to use is present.
The cause could be many causes, such as water damage or simply aging. If the electronic chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water it could be due to the fact that the keyfob was exposed it. In this case you'll need to remove the device apart and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry, you can put the battery back into the battery and try again.
If the issue persists you're probably in need of a idea to see a local Peugeot specialist or locksmith. They can utilize an instrument for diagnosing to identify the issue and then fix it.
The loss of your Peugeot car keys could be an emotional experience. However, a qualified auto locksmith can address the issue in only a few minutes. They can cut a brand new key and program it to your vehicle, so you're ready to get on the road again as fast as you can. Click here to find a local locksmith near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob is a critical role in the remote control system. If it gets damaged, your car may not start or receive a message saying "anti-theft active". In this instance, the only solution is to replace the key. Luckily, auto locksmiths who are professionals can offer the service in the shortest amount of time.
The chip in your Peugeot 308's key fob may become faulty for different reasons, including sweat, water damage or dirt. If your Peugeot 308 key fob has been exposed to soapy water, you must cleanse it immediately. You can make use of a towel and isopropyl alcohol to wipe the electronic component. After that, let the battery dry completely.
Radio interference can cause the key fob to stop functioning. This can be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects close to the vehicle. It is recommended to visit a Peugeot dealer if you have this problem.
The Peugeot Key Fob 207/308 is very delicate and requires particular care. It is not recommended to drop it or throw it around. If you lose it, try to find it as quickly as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a short period of time. Make sure you disconnect the negative first, and then the positive.